thanks for replies everyone
@D_Hailsham
i didnt know what a boiler interlock was exactly i assumed the cylinder thermostat was one so googled is a cylinder stat an interlock and got some interesting articles
this was most promising...
currently the system i have only allows control of hot water and heating via the boiler vokera 14se
i can turn off the heating in the hot press by turning lever
ideally i would like to be able to control heating on both floor levels but to do this plumber says entire system would need to...
found this
http://www.waterdial.co.uk/images/pdfs/instructions/Aquadial%20Microsoft%20Microsave%20Instructions.pdf
page 4 explains controls clearly enough
going through troubleshooting page 10 tonight does seem to indicate defective timer motor from cursory glance
thanks for reply
i will check transformer working tonight when i get back but i assume when i switch dial to start and the unit starts up that transformer is okay
i cant see any markings on unit to indicate brand or model number
the silver pins on the day control should they be pushed...
the guy who installed it cant be contacted
anyways unit is not working properly and does not automatically do backflush anymore
the salt level in tank is same as it was 3 months ago
if i manually switch control to start it will work
last year i cleaned tank out and got rid of all the...
just trying to figure out if this a DIY job or not
in a sealed system where can it be fitted?
i dont have the space to fit it under boiler
can it be fitted in hot press and which pipe should it be attached to
i know post is old but as vokera was fairly standard fit in ireland in the 10 years i think it might help to reply anyways
id imagine your system isnt mains fed but attic fed
pressure will only be 0.5 bar
also i guess no filling loop is fitted
post a picture of pipework in...
how did you get on with this
also have vokera that isnt mains fed and constantly cutting out, no filling loop
attic fed will only give you 0.5 bar pressure probably why no gauge in hot press