Recent content by Berwyn32

Hi, I am about to lease a small shop that used to be a hairdressers. The interior walls therefore are tiled from floor to ceiling with ceramic wall tiles. Is there a cost effective way of covering over these tiles without the need to remove them & re-plaster the walls. I know...

Hi all & a happy new year, although it's been a while since I posted this question, I would like to thank ladylola for advise given. I have completed the job & now have roof beams some 18" higher, the roof is just as strong & had 4-5 " of snow resting on it for several days without a problem...

Thanks for that, I was going to go to the trouble of acro props, removing the existing woodwork then replacing it, But bolting the new beam onto all the existing woodwork & cutting away everything below it will save a lot of time. Thanks again, Regards Dave

Hi, No, sorry if my description was a bit vague? The garages are joined end to end which is why it is such a length, both garages are 4.4 metres wide, the original garage had the end removed & a second garage joined to it, I bought it like this, I am going to build a dividing partition wall...

Hi, I'm new to this forum & hope I have posted in the correct place. I have a large 12m X 4.40m garage, in fact it is 2x garages joined together, of wooden construction 2"x3" beams covered with wooden cladding, one half roofed with corrugated tin, the other fibre type corrugated. I am at...

Running a Computer repair business