big-all's latest activity

  • B
    big-all replied to the thread thank you ebay.
    and another £10
  • B
    big-all replied to the thread Police State Is Here!.
    free speech to be valid point must be accurate and honest most people have well-meaning principles and thoughts when expressing what...
  • B
    big-all reacted to Notch7's post in the thread Police State Is Here! with Thanks Thanks.
    The world would be a better place with the poisonous Hopkins silenced.
  • B
    big-all replied to the thread Is Screwfix forum down today?.
    was playing up as you describe earlier on today including around 2am when i went to bed
  • B
    big-all reacted to Glenn83's post in the thread Floor Joists Question with Like Like.
    Yeah i think you may of miss read the post wasn't turning the joists flat, but running them from front to back instead of left to right...
  • B
    big-all replied to the thread Floor Joists Question.
    miss reading a post, nothing new there then ;)
  • B
    big-all replied to the thread Floor Joists Question.
    general comments the joist support /rigidity/structural strength will be roughly 2 to 3 times as much dependent on cross-section in...
  • B
    big-all replied to the thread Newel post - can I saw it?.
    there is no such thing as "wrongly thought" there is off course "we are all still learning" just have an open mind and listen to others...
  • B
    big-all replied to the thread Best TV recorder box?.
    if you are used to freeveiw recorders like i am a memory stick serves no real purpose as a single tuner will only allow record or watch...
  • B
    big-all replied to the thread Screws for door hinges?.
    not an exact science but measure the screw heads then half it then this will tell you the approximate screw size hopefully its...
  • B
    big-all replied to the thread Newel post - can I saw it?.
    that will be an addition [dowelled on] as its only a half newel, so tap tap tap in several directions around the acorn protected by a...
  • B
    it will be sitting on the gripper, thus it's leaning forward often what happens is once you lift the front by 12mm it will lean back...
  • B
    big-all replied to the thread Screws for door hinges?.
    they used to be no7 [3.81mm]by 1 1/4 or 1 1/2" must be fully threaded what ever you use metric 4mm being the closest...
  • B
    try the non-invasive method first i would start with something like 12mm wide 9-12mm thick and perhaps 50mm long bit off material...
  • B
    big-all replied to the thread Garage Door Locked Out Disaster.
    from memory off my dads up and over from around 12 years ago the only way to free up the shoot bolts was by pulling towards the central...
Back
Top