Sparky many thanks for the promo reply, looks like it needs an expander for extra outs to sole the problem. Could you elaborate a bit more on the light box mods you mentioned as I have neve seen the light box
Many thanks
Bill
Good Morning,
I have a customer Panel enforcer 10 and Delta bell Plus, the Delta bell has the 2.2K Resistor in the tamper circuit. In the panel the return would normally go to Z33 programmed as tamper this is disconnected because the Z33 and Z34 are configured as Wired zones and set to...
Hi josh, the stack I was talking about is vi the iPaddress of the management pc then over the internet to the remote enforcer panel. What needs settings up in the on-site software of the management pc I have set the udl options on a couple of panels but missing how to configure management pc...
I have Pyronix insite UDL on my management pc and planning to remote config and backup of the enforcer panels, does any one know if this can be done via the IP stack on the management pc via the cloud the remote enforcer panels, or can it only be done by modems in the panel.
If it can be done...
I have a customer who has a Pyronix enforcer wireless alarm, When they use any of their key fobs to part set night mode via the I on the key fob this works fine, in the morning when they go to unset the alarm with the padlock unlock it does not function until they open the time entry door the...