Recent content by billozz

Appreciate you answering, The other 3 beads have gone in really easy tbh but not this one, any thoughts on a way to get it in please.

The bead starts ok either from the top or the bottom but when I reach that bit that's cut out it won't clip into place, not sure why they've cut it either.

It doesn't seem to be sealed at the top and nor are any of the others

Thanks I will

Can anyone help I've replaced a double glazed unit and I'm having trouble getting one bead to go in, it's a bit of because unlike the other beads it has a cutout in it no idea why but wondered if that is the problem. Thanks Bill

Do the above pics show anything that might cause the leak, I slid the roof bar down a bit, as you can see there's some moss at the top, took the end off the panel, no water inside as far as I can see, had a good look as much as I could at the roof panels ask seen to be sealed nicely weather has...

Pulled the plastic away and I can see moisture and even a little pool of water where I have marked, I'll take gutter off tomorrow and see if I can see where it's getting in

Will the upstand be visible from either side?

Do I need to remove the gutter to check if everything is as it should be, I pulled back the plastic moulding you mentioned and I could see the ring beam and there was water... Just a bit... Below it. The water isn't pouring in and could be the result of rain blowing up under it, if removing the...

Thank you, are you referring to the joint between the panels or the piece plastic that fits along the bottom of each panel which sits above the gutter.

Thank you for the reply. Do you mean water between the sheets of plastic? And it's pooling at the bottom?

Hi all, can anyone suggest why I have a water leaking in at point shown, it's not pouring in but it's making a bit of a mess. There's no water running down the roof sheets inside, the gutter isn't blocked . Not sure what I should be looking for Thanks

Yes the guy used the old stuff and for some reason it stopped sealing, I bought a new one and that still leaks

Yes of course but I wonder why it's not working and if it's a common problem

Single