Looking for a little advice. I am going to lay laminate in my hallway. I will be removing skirting boards & undercutting door architrave a jambs to achieve a good finish. Now the problem....I have 7 doorways in the hallway to contend with, some of the doors are directly opposite each other. Now...
Thanks for the help. I understand fully what you are saying. Do i need to disconnect the neutral that WAS feeding the Tstat, from the timer? Surely this would be a risk to be left connected??
Cheers in advance once again
Regards
AndyB
I have purchased a Honeywell DT90E (wired Digitel room stat) to replace my current Drayton RTS1. Now i realise that the RTS1 has a 240v feed & the DT90 is volt free (basically a battery powered switch) but what i want to know, before i take anything apart is what i have to alter or...
I am planning to add lighting to the sofits of my detached garage. I have come accross these & wondered if they are suitable & if anyone has any experience of using them...
Please tell me what you think is wrong., you have now got me very worried. I have tried calling a Registered gas engineer today but they are very busy atm. If it is an emergency case, I am sure i could get an engineer out tomorrow.
Andy
Hi,
I would very much like you to be able to guide me in the correct dirention of diagnosis:-
I have a Ferroli sigma 60/100 boiler. From startup it runs fine for about 20 to 25 mins then starts to make a chuffing sound. Difficult to describe in words but it is rather like a steam engine...
Thanks for the assistance. I was just checking up as i have today had a PartP electrician detail an instalation for me today & didn't want to fobbed off!! :roll:
Regards
Andy
I am replacing our Gas hob with a new 6.6kw ceramic halogen hob so need to know where & how to get the supply.
Now, we have 5.1kw double electric oven connected to ccu then back to 45dp switch then by a radial 6mm T&E from consumer unit with 32amp breaker.
Is there anyway that i can...