Recent content by Bob Wylie

Yes it is. It's probably because it's not recharging the full 50 degree delta after only a shower or two, but certainly enough for our purposes. The goal was to effectively have almost continual hot water with one shower running but that was only going to work on paper ;-) Again thank you all...

Hi all. I want to express my thanks for explaining to me what's going on. I had completely overlooked the effects of the appliance loss at that high flow rate. The 40SB was put in about 5 years ago - and forgive me, I can't recall the reasons for the sizing of it at the time, but it looks like...

Hi everyone. Happy reading. Any advice/suggestions would be greatly appreciated. Project Goals Replace an S Plan setup and old cylinder with Intergas X plan and high gain cylinder. Giving a very rapid cylinder reheat time (circa 12 minutes) and embrace OpenTherm control from the Nest Issues...

Hi folks I'm glad I found this forum. I am about to swap out my valiant for intergas HRE SB, and I intended to convert my heatlink to opentherm. Can I see the wiring diagram that Dan and the OP ended up with? Bob