Recent content by Bobbinet

It completed a full cycle.. The only thing I did in between it not working was spraying some contact cleaner on the connector of the flow meter and taking the meter out for a test (which it failed unless I did it wrong). So... Anyone has any ideas?

I tested the flow switch with this method: And the multimeter doesn't show anything. Could this be the result of a broken flow swtich? _ _ _ _ _ _ _ _ _ I put the flow meter back into the machine and now it's suddenly doing a cycle.. I have no idea what to do. If the meter were broken, then...

I know its given me a lot of good years but I just need like 6 more months out of it if I can help it. This is exceptionally bad timing in regards to my finances. Full teardown, eh? :/ I was hoping the video could narrow it down.

This gentleman here suggested it might be the flow meter that has corroded contacts. It could be since water flowed quite heavily from that top soleniod valve.. Some water might have gotten into the flow meter and corroded it... I'll take the machine out again and remove the side then try to use...

I hope anyone won't mind that I made a new thread for my problem. Found the above advice in another thread and I'd like to start with it. Does anyone think my machine could be suffering from the above mentioned problem? It's also from 2004, a G641 Miele. Ran without problems for most of its...