When you do a job for the 1st time it is always best to ask 1st if you do not know the answer than to fail miserably. I have been researching this for about 3 months and have talked with a Heatas engineer who will come and check my work before i finish. I still dont know everything i need to...
Hi all, ive been crawling about in my loft on boards that i layed on top of the insulation doing some plumbing when my upstairs lights went out, ive checked that i have lives to my switches but the neutrals are also showing live on my screwdriver electric tester, all but one of the lights are...
Thanks all for the replies, i only want to heat the Rads and to keep it simple, i dont need to heat the hot water and i have only just bought a new cylinder so im not forking out for a twin coil or a Dunsly, Onetap gave me a link which shows easy ways to connect up via flow and return, this is...
Hi, im looking to see how a multifuel boiler stove could be installed into my existing gas boiler system, with the minimum alterations as access is a problem to changing most of the pipework before i buy one. i have made a detailed drawing of the existing system and have added a proposed option...
Yes i crossed them over where i extended them and before anyone states the obvious, i did label them before disconecting them, they went back exactly the way they came off, if only i had made a mistake hey, i would have fixed it without even knowing it. Thanks again everyone, im sure some of the...
Are you lot just trying to get in a few more pages to get a record or something lol. Job done! i poured water through and to me at least proved the 28mm pipes were crossed when the water came out of the top pipe at the boiler, i then had no hesitation in switching them over. In hind site, this...
Looks like im on my own then, i will let you know how i get on. if it still does not work when i have it all back together i will run your test for the 3rd time Doitall though i dont know what is expected to have changed though by this time the 28mm pipes may be swapped over.
The problem is the pipes go through the chimney at 45 degrees almost side by side, by the time they get to the top they are front to back and are boxed in, i cant tell which is which. Can someone please tell me why pouring water down the 28mm pipe from the bottom of the cylinder wont prove that...
Any more pics will have to be front or back of the house lol, i have given pics of every bit of viewable pipe.
Upgrademe's diagram of how the 28mm pipes are connected to the wrong ends ie flow and return has been the consensus since about page 10! Yes we have gained more of an idea with the...