Recent content by bosch75

Thanks for the comments. The problem is, is that the lift has already been supplied off a sub-dist board and my job as client rep is to argue the case that this is not good working practice. If I were the contractor I would argue..."Show me where it says you can't provide a lift supply off a...

Is there any regulation/standard that restricts the use of proividing a lift with a supply from a sub-distribution board as opposed to the main panel? It might not be seen as good working practice, but the standards I have searched through do not clearly state where the electrical supply must...

Yes the intention is to use dual sockets as well to comply with 543.7 of the 17th edition regs.

I am after some advice. I have a MEM Exel fuse board, and have been asked to provide a new ring main that will supply 8 computers. Would wiring from a 30A fuse in the board through an adjacent locally mounted 32A 30mA RCD be accpetable? Any advice would be greatly appreciated.