Recent content by Brief50

You can remove the postform using a router, for a clean cut edge, then apply a PVC edge. Available in various finishes and look very classy when done. This will allow you to create any curves you wish. Trying to do this whilst maintaining and blending a straight laminate edge into a post form...

Fit the worktop as you normally would and do nothing to raise the cill, you don't need to. Attach a piece to the rear of the worktop, same interior width as the window so that you create a small splashback that sits 75-100mm above the worktop level. You could use a waterproof finish such as uPVC...