Recent content by BruceRee

All workig after adding a loop between Lr and Ls on connection block ST10. :D Thank you once again for the help.

Hi Guys, thanx for all the help and pointers. I have looked on the circuit board side and see there is no loop between Lr and Ls on connection block ST10, the installed must have removed it as mentioned by "Corgigrouch". When I get home this evening I will bridge the two and hopefully the...

I am looking but not sure where it would be located! Any ideas were it would be located on the Wochester Bosch 24i Junior Greenstar?

The central heating dose work but only when you push the button with the spanner on it too put it in service mode! and if you adjust the temperature control it works fine but like I said only when in Service mode... Does not make sense to me.... :roll:

Had a look and the cap is loose about five turns unscrewed...

Cap on the auto air vent you say... Mmmm let me have a quick look....

No room stat. I have TRVs on 6 of the 7 rads. They are all set to max at the moment will adjust as soon as I get the system working...

Hi Guys, I just finished installing my own D.I.Y central heating radiator system and it does not work! Had a Wochester Bosch 24i GreenStar Junior installed 10 months ago after the old boiler packed up 2 days after moving in to the property. The Gorgi Engineer that installed the boiler put a...

Once again thanx for the help guys... Okay so if plastic is not installed properly it could end up being a nightmare. Well the main reason I am going for plastic instead of cooper is because it is easier to tackle as I have heard that if you do not have allot of soldering (sweating) experience...

Hi Guys, I am starting the Installation of my central heating radiator system this weekend and still undecided about using plastic with push fits or copper piping, need to go and purchase the supplies this weekend. Now I pretty much decided to go ahead and use plastic pipe with the plastic...

Thanx for all the help guys it is greatly appreciated!!! :D So I am going for 22mm pipe and T off 15mm to rads... Just been looking at each room and finding out which way the joists go so I can work out the easiest pipe run without having to cross over to many joist. Now Should I use...

On the second day in my new property the boiler packed up and could not be repaired and thus had to fork out a large amount of cash for a new boiler + installation and could not afford to have rads installed at the time specially after putting down a 10% deposit on the new property! Property has...

Stuck need some advice recently purchased a property with no central heating. Had a Worchester Bosch 24i junior greenstar Combi boiler installed a few months back opted not to have the radiators installed at the time because of the cost factor. I am a hands on practical guy and have decided to...