Do you have a link to the jig you speak of?
Also, will I need to take the door off ? or can I swap out one hinge at it time ?
And finally, the holes drilled into the door, I'm guessing the door has a metal frame/core so it should hold, yes ? Not sure whether I will need to tap the screw holes...
You know your hinges, that's for sure.
What do you mean by the black plate ?
Also, I was thinking of replacing the hinges with some patriot flag hinges - is that doable or am I condemned to these hinges ?
Pics attached. I adjusted the bottom ones and it was clipping against the bottom of the door.
Also, the draught gap seems to be about 4mm and these hinges can only do ~2mm but it seems like they don't want to budge much vertically either way unless it's downward.
Hi Guys,
My upvc door is not sealing properly at the top and has a small gap from where air can get in.
I am guessing that I need to move the door up a few millimetres.
I am not sure however which screws to tinker with. Most of the videos I have seen show a cap on the top or bottom of the...