Recent content by CAESAR32

That's hot out. Vessel has internal expansion.

The pipe on the left is definitely the hot outlet. There is no secondary return etc on the system

Correct in saying you'd still have 0.6 bar coming out untill the water level in the cylinder drops below that pipe. Is about 6meters above the kitchen sink. But if the hot feed came directly out of the top shutting the cold mains would stop the flow of water straight away

I imagine the pressure in the cylinder even with the mains off would keep water coming out until the level falls below the level in the cylinder. Cylinder is in the 3rd floor kitchen tap ground floor. Or am I wrong?

Hot outlet here

If you shut the mains cold water off in a house. And you have a mains pressure hot water cylinder on the top floor. By turning off the mains would this stop the water for coming out the stop tap on the kitchen or would it still drain the tank to the hot water draw off point on the cylinder

Can a brass male thread thread by sealed effectively to a female thread that is plastic?

Would a too small cable lead to the fuse tripping?

It's one that already installed. I'm questioning the installation as opposed to MIs. Must of been done by and electrician as the ends of the cables are crimped if that's what you call it. And has a special earth connector on the earth.

It's about a 1 meter / maximum 1.2meter run from the spur

What size cable should be used on a 2kw supply from a fuse spur? Imagine there is a few variables

Thanks. What best to cut the unit with when the time comes

Does that sound okish?

Thank have brought it in so when plasterboarded and tiled, the back of the 110mm pipe will be about 25/30mm from the finish wall

The is quiet abit of work to swap for a hive then. As this stat just does heating, if swapped for a normal stat. Would any single channel programmable one do?