Recent content by caveman2

Thanks for the advice/ info. I think that covers the questions and I'll pass it on. Many thanks again.

Enquiring for a friend as to issues re. EV Charger install. As he has an all electric kitchen ie. dish washer, induction hob, washing machine etc. and only a 60A main fuse. He realises that his DNO will need to fit a 100A main fuse. Before he books an electrician, he intends to contact UK Power...

Thanks all, for your advice.

I would like to keep a variety of size and length screws, rather than having to go out or order when I am doing a job. I am only a DIY'er and don't use that many to warrant 100/200 boxes. To this end I found a site "CheapScrews" that can supply me with say 4/4.5/5 in 40/50/70mm in small volumes...

Thanks OB. Those calculations are spot on for my house. Therefor with only .375 and not the minimum .5, I cannot use that tap. Is the only solution, to find one without those restrictions and why are they imposed on that tap and others that I've seen with a similar .5 bar minimum specified...

Sorry to resurrect this thread. I am replacing my Franke mixer with another (35 years apart) but. The recommendations are for minimum .5 Bar. How do I know if I fulfil that criterion. I have mains cold and gravity fed hot from a copper cylinder in the storey above (bedroom) and the cold water...

What isolator valves would you recommend fitting under my sink. Peglar isolator valves with screw, the same with small plastic lever or the larger Peglar ball valve?

Thanks both of you. I appreciate the new tap will have flexi-hoses, I only mentioned the fixed pipework to explain the type of assembly. Removing the nut is going to be a "joy" with little space to work with and having no box spanner that size.

I have an old 35 year old Franke 2 bowl sink and mixer tap. The tap needs replacing but I need assurance that the new one will fit. The old tap has a 30mm threaded column to which the H&C feeds are sweated into it. The whole assembly is then fixed with a 40mm brass nut. Will a modern mixer tap...

30yr. old build. Solid floors on ground floor with cables fed from upper floor down and back up again. Ring main not lower and upper but East and West

Many thanks. I assume then that I could buy and get it quicker off Amazon if they are universal size.

Thanks for the reply. Do you then dispense with the whole fitting device supplied by Wren. Do you fit one bracket to the wall and a similar one (but reversed) to the back of cupboard or do you buy separate brackets.

Fitting Wren wall cabinets and noticed the mounting fixings are in the top corners. If I find that there are cables in the wall where the screws would need to go - how do I get over the problem. The base units wouldn't be a problem as the fixings can be moved along but I don't see a way to do...

Thanks all.

Just to confirm then that the 2.5" of air space in my dipper under the output hole is OK. I got confused as some questions asked when googling refer to syphoning problems and I cannot remember whether the water level was ever under the bottom of the dipper. I if had been, I'd have to bend the...