Hi
I have the above powermaster GT 64 alarm panel and am awaiting delivery of the gsm data communicator and wondering if anyone has a setup guide and how to connect the visonic go app as well as recommending a cheap sim for the unit.
Thanks
Hi
Sorry but it looks like I listed the wrong Nest product and its the Nest E thermostat. It looks like the heatlink is connected to the thermostat wire and the thermostat plugs in to the wall via a usb charger. I have a programmer old fashioned dial timer attached to the boiler.
Sorry for...
Hi
Looking for advice on how to replace and label the wires
on the Myson MRT1 Thermostat to wire on a Nest 3rd generation thermostat. Looks like 3 wires as I think the brown at T3/4 snakes around back of grey wire to T1.
Thanks in advance
Hi
I powered down the alarm panel by removing both the battery and mains power waited a few minutes and connected the powerlink module 1st then battery 2nd and mains last. Repeated the procedure with mains 2nd and battery last and still no joy with the panel seeing the powerlink module. I...
Hi
No the router does not see the panel and there are no activity lights on the routers port where the cable is plugged in. The module is not listed in the "diagnostics" menu to test it
the manual states "if the broadband module is not registered to the Powermaster, the menu BROADBAND MODULE...
Hi secureiam
I reset the panel using the DEF pins to give me master Access as I could not remember my code at time of installation
The alarm works as it should with no errors etc
It's connected correctly as it connects via small ribbon cable and it connects only one way - I have built many...
Hi
looking for help with this system. I recently installed the above alarm and broadband module. At first I could see the module in diagnostics menu and ip address etc and then reset my alarm (don't ask) then the module stopped working I assume as I could not see it in diagnostics to check...
Hi
I purchased the above alarm and did a DIY install. I have somehow locked my self out of the Master installer menu and only have installer menu access. Does anyone know how to reset this alarm to factory default so i can install and remember a master code? I have contacted the company that...