Recent content by Cheaps

I think you could be right, I'll get a replacement tomorrow. And no, it's not in that pic – but it is now.

Yes of course i've tried to screw it on!! :D Its farrrr too small. Just to be clear, i'm trying to fit this cap to the part of the isolating valve that once was attached to the red plastic washing machine hose. As you can see in that top pic, that is about 1" in diameter, the cap i was...

OK, you all say the 3/4" will fit, but as you can see from the first picture the 3/4" cap i have is far smaller than the connection I've removed. (both shown side by side in top pic). No amount of ptfe tape is going to change that.

Sorry, should have checked the forum more thoroughly... Forgive me for being a div, but isn't this a 3/4" cap and its too small. Or should I be fitting it at the pipe end?!

hi, i've just got a new washing machine which only uses a cold feed, whereas the previous one had a hot and cold. The isolating valve on the hot has a very slight drip now that i've closed it off, so i want to cap it off. Is that possible, is there a large enough 'cap' to do that? It looks like...