Recent content by chiligee

One person on the forum asked why I chose combi over system boiler. The apartment currently has a over 25 year system boiler and copper tank. The flat is rented. by getting a combi, i'll get room as the cylinder and storage tanks go. However, I recall an engineer tell me that on...

Hello all, I've been reading many posts that are 2006, 2007, some 2009 on comparison of boilers. I believe much must have changed. I'm looking to choose between the following: Potterton Promax HE PLUS A 33kw. Gives 15l/min DHW @ 35 degrees at a cost of £800 incl Flu kit Vaillant...

Dear all, thanks for reading this post. Kit installed: Ariston Unvented Cylinder & Valliant system boiler I'm having 2 issues; water hammer and low pressure problem. Background information Since purchasing our home, we fitted a megaflo system + new boiler and moved this to the...

i believe maybe cant see dimensions clearly. So attached a new image

Dear forum members, I would like to seek advice on the wall I need to set up sliding wardrobe doors. I have a beam area and would need the top track to be suspended as the ceiling is higher than the sliding doors. Also would like advice on where to purchase doors from? I estimate...

sliding door measurements

Went back to the flat, reduced the pump speed to 1 as i have a few radiators - following recommendations at this forum. However, i have another puzzling issue. I decided to bleed all the radiators just in case. There are two radiators which when bled, do not remove any water or air - but...

Many thanks JohnD, First i had better reply to your questions. 1. Zone valves. When i put new zone valves, it was asmost the same price to buy only the mechanism as well as mechanism plus the valves. I purchased the full lot as can be seen in this pic. i purchased two of these for...

Hello. I have an issue with my potterton profile boiler - gravity system (not combi). I better give some history about this. about 9 months ago, the boiler packed up. I ended up changing the PCB - the circuit board with a refurbished one from the local merchant. Gave him my PCB and...