Hi everybody
Boiler now working orange wire had broken down tested voltage at board voltage correct checked voltage at 3 way 0.2v replaced wire HOT WATER YIPPEE... or words to that affect A BIG THANK YOU TO EVERYONE who gave me advice.
THE OLD 3 WAY STILL DIDNT...
hi tony
Could you explain this in a bit more detail
One thing that I would find reasuring is if you can put a diverter valve into the DHW position and fit it to confirm that when the diverter is correctly set for DHW that the boiler will indeed operate on DHW OK.
Cheers...
Thanks chris
this information is most useful so i can check pcb out and check for voltages stated (i originally come from an electronic background)
many thanks chris
Will let you know either way cheers
hi everybody
yes thats right chris so i could really do with an indepth circuit diagram .The one with the boiler is pretty basic so im going to ring chaff et technical helpline in the morning see if they can give me some output voltages to 3 way.If not suicide is always an...
cheers meldrew's_mate
All connections in right place
cant hear motor move but will try old 1 see if i can see it move
dont suppose you know the switching voltage from pcb at the moment can only detect 0.4 of a volt going to 3 way.
thanks again chris
hi
If you know the name of the profile (rehau spectus etc) you can buy something called"knock on or add on" that clips in to the profile to add width or height it is mainly for deep plaster lines but would do the job for you and is available in various depths silicone and screw for best...
Hi
roobarbthedog is your door a full panel door or half and half, only if you take the panels out it will allow you a bit of bend in the profile that may allow the rollers to pass the keepers. If not the only other way is to burst the keepers by putting force on the point of roller meets...
hi
Im looking for some advice on a britony combi 80. When the hot water tap is turned on the radiators warm up and the hot water system stays cold now according to the fault finding page in the installation manual this fault is down to the 3 way valve? Which has now been changed but fault...