Thanks Stem.
I will take a look at the PCB and start chasing the wire that gives the +vet feed.
The only reason I was going down the bimetallic contact thermostat was I remember that the engineer who serviced the boiler said that same pipe was leaking. During the summer so heating was always...
Sorry I should have said that on this bimetallic contact thermostat there are 3 connections.
The installation leaflet says:
Terminal 1 = common
Terminal 2 = opens the circuit when temperature rises.
Terminal 3 = closes the circuit when the temperature rises.
The wires are connected to terminals...
Hi Stem.
Firstly, many thanks for your reply.
I have made the assumption that the programmer is working as it switches on (respective CW or HW lamp illuminates) when the timer function tells it to.
I have tried your recommendations and can advise that:
Mains available at boiler and programmer...
Hi all.
Please can I ask for some assistance if possible?
We have a Gloworm Micron boiler controlled by a Siemens RWB9 programmer.
The timer function works correct at the programmer but the boiler runs continuously if allowed to! Regardless of thermostat, frost stat or programmer setting.
The...