Recent content by Chris298

Morning all, As above I am wanting to fit a Nest to my Glowworm Betacom 30C. I’ve read a very helpful post on here which says I can take the Heatlink and put 230v in to its L & N, and then using the 24v connector block on the boiler, wire that in to the 2 & 3 on the heat link. That sounded...

Thanks Terry I'll have a look. Didn't know if it was something attached to the boiler itself or not.

Thanks Terry I will give it a go. Just so I can try and make efficient work of it, where is the drain cock likely to be?

If I'm honest I can't say 100%, however I believe the pressure was zero when I did it. What I can say is that no water came out of the valve, and when I put air in to it, I could hear the sound similar to a balloon inflating. I seem to remember the problem being there fairly straight after...

Evening all, This is by no means a recently occurring problem but I'm finally getting around to looking at it. I have a Betacom 30C Combi Boiler. Once the boiler has been running and heating the house, once it stops, the pressure drops to totally empty. This meaning I'm having to...

I know this is years old now. But I’m looking at putting a nest thermostat on my Betacom 30c. When you say the low voltage connector, do you mean the blue connector block on the inside of the control panel when you flip it down? So the heatlink has 4 wires going to it, a L and N from a 240v...