Recent content by Chrisg88

Yeah i tested betweem circuits with nothing showing. It really has me stumpped. Tomorrow should shine a bit of light on it

I done a bit of digging online and seen similar problems. Some people mentioned parallel paths but i domt see how there could be with all test ok

Yeah i tried it a few times even tried with other circuits energised only seemed to be the the kitchen

I havn't but im going back tomorrow for further investigation.

It carries on until trip. My readings are >300 for x1 and >40 x5 I did think that the meter could be playing up but just strange as its only that one circuit

Its an old install with new rcbos

Its a brand new rcbo aswell

They are right next to each other in the board, no its an empty flat so nothing plugged in

That was ok, only when testing cooker with kitchen energised

Yeah 24mA on both occasions

Hi i have just came across something on an eicr i havent seen before. Set up is a db with mix of rcbos and mcbs Tncs system All tests on all circuits are great. Theres rcbos for the house ring kitchen ring cooker and shower. When testing the trip times for the cooker circuit it was tripping...

The company i work for do occupied rewires in one day it can be done 2 sparksa labourer and a plasterer so if its a single floor it could be quite straight forward for some companies

Hi all. Just to see your opinions on this. Started work on a local authority housing job. Wiring showers in highflats. The spec is 2 way rcd enclosure with 40a mcb and the other way blanked off. We are to use 10mm tails into henleys. 25mm tails in use for cu and 100a main fuse. I say we...

I love how discussions on most thread end up with everyone discussing the OP$s existing install amd getting further way from the orininal question

Yeah it was pre payment. The person had just took it out. To be honest that was the least of the problems. The flat had 300 used needles amd was totally wrecked. Compele crack den.