Hi
I've been researching and come across this product - BIN Primer Sealer. If I sand the part where the new plaster meets the 'old' part of the wall and then used this BIN primer sealer and then emulsion over this - does anyone think this will do the trick?
I'm pulling my hair out with...
Hi All
We had pieces of slate surrounding an old fireplace. The slate was stuck on with silicone. The slate was removed and the area skimmed over with plaster. Once the plaster was dry this was sealed with a mist coat (watered down matt emulsion). I have then applied a silk emulsion and...
Hi All
As you can from the picture I am attempting to connect some brickslot drainage to a 4" clay pipe. I plan to position the brickslot in front of some railway sleepers. The reason I putting a drain like this in is because I plan to flag an area which was previous part grass and...
Sorry for not getting back sooner been out of action on the PC.
Thanks very much for all the advice.
Are Timberlok the standard for screwing sleepers together? Could I not use some heavy duty angle brackets (for the return) with a couple of timber posts concreted in and screwed to the...
Thanks Deluks.
No, I haven't got an impact driver. I'm going to ask around to see if anyone I know has got one, otherwise it'll be the hire shop. Forgive my ignorance but would a good cordless screwdriver or drill not do the job?
The sleepers are pine and I was told that they should not...
Dear All
Great site!
Can anybody kindly recommend what size screw Timberlok/Timberfix screws for 120mm deep tanalised sleepers? I have read somewhere that the screw should go into the next sleeper by at least 50mm but the only size screws I can find that would do are the 150mm (too...