Recent content by CluelessSteve

Hi, I have almost an identical situation as the OP. However my system has nothing in connector 3, but two wires in connector 5. I assume this is both CH and HW off merged into one. So, I wired it up using the FP715 wiring conversion chart as supplied, and put both wires into connector...

OK guys, so - after looking on the danfoss/randall site, I found this one.. http://danfoss-randall.co.uk/xxTypex/287408_MNU17416279_SIT313.html In there it talks about gravity vs pumped hot water. Erm.. Ce? I have an immersion tank that our how water is stored in, would that be gravity...

Ha! Looks easy enough, although knowing my luck I'll take the cover off and a plate of spaghetti with a few crusty old spiders will fall out. I will have a look for a digital timer and see if I can find one that is simple enough to fit. Cheers!

Hi, In that case, a resounding "NOPE" :) So my next question is, can a new boiler be moved to a place such as the loft - easily? Steve

Hi, I am not entirely sure what you mean. The current timer controls both HW and CH. The problem is that the dial is not spinning hence our heating and water is on full time. I want to replace the timer with a more modern one, perhaps with progammable times for each day. The advice...

Hi, I live in a house built in the 80s. It has a normal boilder that heats the hot water and central heating. I think the hot water is stored off in an immersion tank in our airing cupboard. I am completely clueless when it comes to central heating and plumbing.. But can provide further...

Hi All, I am a complete idiot when it comes to central heating, and we have just moved into a new house. On arrival I found that the timer dial on our Randall 4033 timer is not spining, although I can hear ticking. Heating / water is able to be switched using the switches, but I want to...