Recent content by congresstart

The part that's failed is circled with a close up in the other image

Hi all, I have 3 bathroom mirrors with sensor lights, 2 of which have failed...I suspect the third is incoming. I'd like to replace the transformer for sensor switch on all of them, but I can't seem to find an exact match for the part. Would this work...

Hey thanks for your help on this! I have now replaced the diverter cartridge, which looks to be working. After turning the isolation valves back to where they were it seems I have water leaking from the screw, guessing I did something wrong? Things look to be working but with the screw on the...

Thanks, I think it'll need replacing with this Hudson Reed Diverter Cartridge Valve

Hey all! I generally don't use the waterfall shower in favour of the small shower head. When this is in use the waterfall head drips cold water. There doesn't look to be much to the outlet, how do I stop it leaking? My guess is maybe something is worn out in the main control/tap unit?

Hey all, I have two areas that aren't getting heat, my googles seem to suggest an airlock/blockage of sorts. I've attempted to flush the system through, see links below for actions taken: Tank/Boiler - Open fill valve Manifold When draining this a tiny bit of water is flowing out but not...

It's something that's been an issue for the last 6-8 months, I'm pretty sure it was ok before this

Sorry for the late response on this. I've attached an image of the tank. Could the undersized pipe feeding the cylinder be replaced if required?

It's at the same level as the other units around the house, I've attached an extra image showing this.

Hey all! I have 4 of the same model toilets around the home. 1 of the upstairs units can't flush the smallest amount of paper. By way of testing, I've switched the siphon unit from a working toilet to the problem toilet with no change. What should my next steps be?

I have cylinder type tank downstairs alongside the boiler. This model

I have a water tank and boiler linked to 3 showers. When turning on the shower the pressure is great for roughly 10 seconds then it slows down, it's not terrible but I'd like to keep that initial pressure if possible? Is this set somewhere on the system or perhaps just a limitation?

Hey all, I had a hot/cold kitchen skink tap changed over to a mixer around 6 months ago, I've had to clean what looks like rust from the base of the tap almost daily. I've attached an image below. Is this likely to be the tap or something within the pipe system at fault?