Recent content by damianstubbs

Perfect, is it worth going for the texecom rm8 relay module to keep it all simple? Cheers

Thats great, regret not going for larger panel witn relay output! So a relay is required! I will bench test the bollard next to the panel just to make sure it doesnt throw me any surprises and let you know. Many thanks Alarm

You were both right about the bollard, the above wiring chart is what came with the bollard. Is there any way you can trigger this to rise when the alarm sounds and go down when it is reset on the premier 48 control panel? Cheers

The 'zero' allowed me to change the expander 2 output options so thats all sorted, just have to figure out a panic button and a frost alarm and i will be all set! Many thanks to you both!

Jibbeh, I will try that 'zero key' and see if that then takes me to expander 2 output options. I did sid see that output 1 on expander board is preset to guard, so what I have done for the time being is wire the siren into '-dc' and 'output 1' which means it isn't going off constantly but...

Hi, Just installed a Texecom 48 with 23 zones using 2 expanders and the control panel for zones. All gone well, but I can't program the outputs on 2nd expander box. I can program the outputs on the first expander box, but the siren i have wired into ouput 1 on the second box is continually...

Thanks for all the help. I will check the bollard which is a bft stoppy L tommorow. Hoping even if it does use a normally closed or open switch it wont be a problem?

Thanks for the very fast respone. Which output would you use on the control panel for the bollard as it needs a +12v to operate and the two sirens are already using the bell output?

Hi, Just in the process of installing a Premier 48 Alarm System which I want to run 2 Master Blaster Sirens off which will run from the External sounder connection. But I also have an automatic rising bollard installed which I also want to trigger when the alarm goes off, but I have three smoke...