Recent content by DamonR

great thanks

oddly that could be easy to do in this case, as where the panel is there is a hole through the wall into a void on the other side of the wall in question. what is the receiver called? could not find anything on the texecom site. thanks

hello I have a premier elite 64-W, I have poor mash connection due to a thick wall with two PIR's, can you get wired or wireless extenders for this? if so what are they called?? thanks

Thanks for the info

bum.... lol issue i saw with the smart com, is that is used both the com ports, but i want the com IP for smart home integration

It’s an elite 64, trying to do this via com IP, frameware was just updated to latest

hello Guys trying to connect up to texecom connect, i think i have setup eveything ok... when you select "ARC 1" and change protocol to Texecom connect do you need to change any of the defaults it loads, i noticed on the IPs pri and sec it has a / for the port number and not a : is that...

this was a cable issue, replaced and now fine, thanks.

yup tried pushing buttons, also tried loading defaults, have removed the comIP only thing added, can you do a factory reset somehow??? have logged a ticket with texe.com as well now.

yes live panel lol

ahh get you

front keypad is plug into the "engineer REW" port, which i think is correct, its not in the com port. its not a LIVE system, i have it for testing integration with control4.

new out of the box, power up few times fine, has had a comIP fitted and has been working with that connected only has one PIR and bell attached, but now is not loading, even with comIP not connected

for some reason my panel is not loading, shows v10.100 Add=001 w-7,7_s been like this for hours

was the cable, used a different cable with no issues