Recent content by Dan147

Thanks for everyone's advice. The hive system is now up and running! (Pictures attached). I have one more question as I'm not sure if one further step is required to complete the instal. Next to my hot water tank there is an additional stat, looks like it just controls the hot water tank...

Echo can I run a quick question by you? The 4 wires (2 light blue and 2 dark blue) that can be seen on the far left of the controller - these are also marked as N at the top. Just to check - Are they internal wires that should be connected together in a connector block and tucked away with...

Echo thanks for the detailed response - very thorough and clear even for a novice like me! Yes I can currently select hot water and heating seperately with the EP2002. - But I haven't checked that it actually only turns on the one I selected. I'll give it a go with installing the hive and...

Hi everyone First time poster and DIY enthusiast. I'd like to install a hive heating system to replace a Potterton EP2002 programmer. The EP2002 back box looks quite daunting with loads of wires - nearly put me off the idea of doing this myself. I'm looking for advice on how to install the...