Recent content by DanAl

Got it, cheers secureiam.

I'm not sure I follow secureiam. Is the guard access zone set correctly with the 'A' and 'E' attributes activated, or was the default just 'A' activated?

Cheers secureiam, your kind offer is appreciated. I think I might have figured it out. When I checked via the keypad, the entry/exit 2 attribute 'E' on the PIR wasn't set, just 'A,' which I presume meant that the entry delay timer wasn't activated.

Great, I'll do that for keypad. Panel was commissioned via Wintex, so I'll have to look at the PIR sensor settings at the weekend. I know it's set to guard access and not entry/exit. Perhaps it needs the two checked?

Cheers. Version is SW V5.00.03LS1 The Guard Access PIR sensor doesn't activate when we set the entire alarm or part arm it from the keypad and then walk past it, or when we re-enter the house and de-activate the alarm from the keypad. It just triggers the alarm when we come downstairs in the...

I do have the engineer code. Part-arm is set by entering the user code, pressing the part-arm key on the keypad, pressing 1 on the keypad and then pressing enter in that order. It's a lot simpler than it sounds in writing! The PIR is currently set to guard access as we have to walk past it when...

We have a Texecom Premier Elite alarm which has the part-arm function set to arm the ground floor at night. The one keypad in the house is on the ground floor. At the moment, the ground floor PIR sensor which we have to walk past to access the keypad in order to disarm the part-armed alarm in...

Thanks RF Lighting, I thought it might be. I'll go ahead and do that.

There's a notch in a corner of the faceplate, but when I tried to put a screwdriver under this to prise it off then it seemed to place undue stress on the faceplate which made me think I might just snap it. I suspect that this is how it should be removed, but I didn't want to assume. Thanks...

Thanks Mottie, I'll have a look tomorrow.

Sure, I'll do it tomorrow in the daylight. Thanks.

Thanks Mottie, I've checked the sockets using a working cable and device. The wires to the 4 sockets themselves run together and some of them work, so the problem is almost certainly the sockets. I just need to know how to remove this faceplate?

This is likely a question with a ridiculously easy solution, however whatever that solution is, I don't know it. How do I remove the face plate from this screwless 4-gang rj45 socket please? I've tried levering it off using a screwdriver under one corner and it feels like the faceplate might...

Thanks opps, I appreciate your advice.

Tesco do kitchens?