Recent content by Daniel1994

Hello , had the cover off the other month and saw this gap around the boiler flue duct. Just wondering what should be around it as it doesn't look correct? Should there be a gasket around it? Boiler is an Ideal W2000 Thanks in advance Daniel

I’m more than capable to change it. Was just wondering if anyone has more knowledge than me on these boilers ================ No you aren't ================

Hello, I’ve got an ideal w2000 rs30 gas boiler. I’ve got a bit of an intermittent problem. When I call for either hot water or heating the boiler doesn’t fire up. Sometimes the boiler comes on but if I boost it for 30 minutes it goes off within 10 minutes. I can here the motorised valve...

@Madrab The end with the o ring is threaded

They look pressed into the casting of the actual tap

I was asking on here as i couldn't find what I'm after.

Its threaded so obviously it needs to be a female flexi but i can't see how there will be enough space there

Thanks for your help but i can't find it on there

Hello , Bought a ex display tap and sink the other day and I was wondering what Flexi pipe I need here. I want a compression fitting the other end but what goes at this end. Pretty sure its 3/8". If anyone could send me a link that would be great. Many Thanks

The thermostat is a danfoss rmt230. Should I bridge the connection like I drew in photo?

I'll obviously remove the browns but you mean like this?

2 and 3 on the red connector block will be used directly for the nest stat and to the heatlink. Then just put a wire into 2 and 3 linking them together ?

Hello, thank you this is the stat

Hello, would this be correct? Take the white wire from number 8 and putting it in number 3 ? Number 2 and 3 (brown) will then be taken out from there and wired directly to t1 t2. Can some please just clarify is this is correct?