Recent content by Davey035

The electric has first fixed a house and a couple of cables exit the block work externally I need to seal these before the plasterer daubs boards on. What is best for this?

Is soldering this on then a 15mm Olive a better way than the internal reducers? I can solder ok.

The fitting is a long tail 15/10mm reducer. Is that not what you meant?

Do you mean solder that on to the 10mm then use the 15mm olive that comes with the rad. valve.

Are these good for using in rad valves for 10mm copper. Have had trouble with the two piece ones before. The ones without an olive

They would be yes.

If putting trvs horizontally can you also put the lock shields like this?

What is it like 8 15mm elbows to do the job? There not too strict I hope

Is there a distance soil pipe bosses should be apart if there bossed in on opposite sides of the stack?

Thanks I wonder how it will work, it's obviously not a in and out in day to swap to a air source heat pump

Orders the mats?

Thank yes would be heat pump installation.

Did you use to work for them? I'm apprehensive after they got rid of loads of people due to the new contracts

Has anyone got any experience of working for British gas? I know there was an issue with the contracts a while back. I was looking at the heat pump installer jobs they are advertising. Thanks