Recent content by DCP180

Not sure how to go about bleeding through the return ? Just had a call with Terry ( thanks again !) Going to drain rad etc to check locksheild and try and dislodge with some air. will hopefully report back when working !

If it makes any difference just went on the Baxi site to check the code and its related to overheat , though most other websites list it as circulation. Il go round and reopen them up and reset now.

Just checked again now and it was cold , checked boiler and it has thrown a E125 code which is apparently circulation fault.

The guide i followed left me with pretty much every rad on a quarter from off on all locksheilds and had this one fully open trying to get it hot, all other rads still hot at a quarter

Pic attached of radiator, Its a Combi boiler system

Just been round and closed them up , right now the top that would get warm is a lot hotter , but bottom still cold , maybe a little luke warm but could just be the tops that hot its radiating off it i guess. Il give it half hour or so and report back.

Hey all , If anyone can help with this id really appreciate it as its driving me mad and am freezing ! Living room rad has never worked as far as i can remember since we moved in. It gets how at and just past the TRV , the inlet at the TRV on the rad is hot , its luke warm along the top but...