Recent content by deepred

I know this topic is old now and the job in question has been done by now, I hope, but if anyone else like me has a good look at the the subjects then any comment may be valid... I would be very cautious about fitting a belfast sink in this fashion, though it is common practice and one I have...

I have used an hitachi for some 15 years now, 6 of those on a daily basis as a kitchen fitter. It still works fine despite being submerged once in a puddle and suffering the usual abuse; no chuck key! wheres me ammer?. Bosh are very good, but buy the blue ones and not the green if you can as...

I use a programe called 'mega mp3 splitter' which is free and works quite well, however it doesnt always work. There are countless programes out there that will do the job. Just put a search on for mp3 splitters

errrrrrrrm, bet you have done it by now. What i would do is measure the distance from the edge of my template guide to the edge of the bit, giving me the size of cut. Draw round the insert onto a piece of ply and using the measermeant obtained earlier, draw a line inside the first one, just...

Though intimidating at first, the wprktop jig is not difficult to use if you approach the job with care. Check that you have it set to the correct setting for the top ie 600mm and bear in mind that some tops are 615 deep. More up to date jigs allow for this cut from left to right, turn the top...