Recent content by dekesta

Hi, I know this has been discussed a lot but I’m looking to convert a second floor loft space into habitable rooms and I have an open plan ground floor. I don’t want to partition the ground floor and don’t want sprinklers so I was looking at using a first floor external door leading to a flat...

Thanks for everything guys, I have learnt a lot over the last couple of days, most importantly - start with the basics. It turns out that it was the wall stat that was set too low. :oops: cheers Deke

oh really, i thought the stat would cut the power to the mech valve first. I will have a good look and check . Thanks

Thanks for that, thats really impressive, however I think I have made a monumental error, I don't even know where the room stat is, so now I presume it is set to very low. When I get back later i will check and get back to you all, but thanks for everything so far. Deke

B is connected to the cylinder. what should the set up be?? where should the pump be?? And why would it make a difference, surely there should be voltage for the valve when the ch is turned on wherever the pump is?????

ab

I moved in about two months ago, and never needed the ch i used the hot water but never thought to try the ch, so yes it has always been like it. So the setup must be fine.

yes, if i remember rightly it is on the tee arm of the valve, and just above it. is this wrong??

When re fitting a new synch motor did I need to install in in a certain way?? or just stick it in??

the pump is about two feet above the motorised valve in the cylinder cupboard

Hi, im new here and could really do with some help please, especially as it is getting colder now!! I recently moved into a house and tried turning on the ch but only the pump came on, the boiler didn't fire up at all. Then i tried the hot water and the pump and boiler fired up straight...