dishman's latest activity

  • D
    dishman reacted to jj4091's post in the thread Re-sealing worn o-ring? with Thanks Thanks.
    Is the heater unit not available?
  • D
    dishman reacted to Alec_t's post in the thread Re-sealing worn o-ring? with Thanks Thanks.
    If you're really determined, and like a challenge, option (c) is to make a mould and cast a seal in silicone.
  • D
    dishman replied to the thread Re-sealing worn o-ring?.
    at £159...i think not..... :ROFLMAO: I have actually done something similar before when repairing a door seal on a tumble dryer....so...
  • D
    dishman replied to the thread Re-sealing worn o-ring?.
    Alas, I have used the exploded diagram but to no avail. The actuator mechanism and the grommet/o-ring is the underside part of that...
    • hcu.png
  • D
    dishman replied to the thread Re-sealing worn o-ring?.
    Seems the o-ring is not what i thought..... Whilst prodding and taking a measurement, I realised that that gray doughnut was actually...
    • dishwash5.jpg
    • dishwash4.jpg
    • dishwash3.jpg
  • D
    dishman reacted to jj4091's post in the thread Re-sealing worn o-ring? with Thanks Thanks.
    Not really into dishwashers, but if you want to keep it going is there a sub assembly you can replace can't really tell from your pic...
  • D
    dishman replied to the thread Re-sealing worn o-ring?.
    I'm not removing it to find out....yet. But the internal diameter of that hole is 2.5mm, so assuming that o-ring is sitting in a...
  • D
    dishman replied to the thread Re-sealing worn o-ring?.
    Ok, I might just try that Moly stuff and see how it goes. Just checking there was not a better solution I was missing. If that moly...
  • D
    dishman reacted to steven lee's post in the thread Re-sealing worn o-ring? with Thanks Thanks.
    Molykote 111 is the right stuff for this. It is a silicone grease so it is safe on the rubber and it will not wash out or dry up the way...
  • D
    I appreciate this might be classed as an appliance issue, but it is more about sealing a worn o-ring. I have a bosch dishwasher that...
    • divvalve1.jpg
    • divvalve2.png
  • D
    dishman replied to the thread VW Crafter Adblue.
    Yeh, there is that too, certainly never brim the tanks. I have a citroen and I tend to try and keep it around the 80% full mark. I...
  • D
    dishman replied to the thread VW Crafter Adblue.
    Adblue systems on most manufacturers tend to be quite temperamental, but there are a few things that have been advised over the years to...
  • D
    dishman replied to the thread VW Crafter Adblue.
    That is your adblue top-up warning. It usually means there is a need to top up the adblue before it runs out. If it gets too low the...
  • D
    The issues I had with my main dealer stemmed from the complete lack of interest from their service manager. I guess maybe he has been...
  • D
    My actual oil and filter service came to just over £140 in the end + the MOT. So just under £200 all in. They stamped the book to that...
Back
Top