Hi there,
I would greatly appreciate some advice. My radiators upstairs are red hot whilst the downstairs ones are cold. I've looked into balancing the system and this does not help. I've also tried bleeding all of the radiators which does not help either. The pump seems to be rotating by...
Hi there,
I would greatly appreciate some advice. My radiators upstairs are red hot whilst the downstairs ones are cold. I've looked into balancing the system and this does not help. I've also tried bleeding all of the radiators which does not help either. The pump seems to be rotating by...
Ok, so I drained off some water and the F&E tank refilled itself. So I'm looking to take a closer look at the pump now.
Question: Can I drain down the system to just past the pump, instead of draining down the whole system? That way I'm only draining the cold feed length of about 2m + the...
Great, thanks Jackrae! This is helpful. I know for a fact that the pump is vibrating but I suppose I need to take a closer look to see if it's all working as it should.
Many thanks for your reply Hugh. That's interesting, because about a week ago before the boiler issues, the toilet cistern was very erratic in refilling. It seems ok now, but could this be related to a blocked cold water feed and therefore lack of water in CH system? I'll certainly try what...
Hi, I would greatly appreciate some advice. I'll try and give as much detail as poss, whilst trying to keep it short.
Boiler: Barlo Balmoral 55F, approx. 15 years old (not Combi type).
Pump: Circulation Pumps Ltd CP53 fairly new.
PCB and Solenoid 1 year old.
Problem: Overheat...
Hi there,
I have a Halstead Balmoral 45F gas boiler and have recently changed the PCB (on which a component had burnt out) and the pressure switch (which I understand wasn't working). I'm not sure if the two problems were connected, but I changed what needed changing. Now, when I turn the...
Hi,
I would be very grateful if i could get some advice on new foul drainage to an extension i am currently designing for a friend.
Currently, there is an SVP that runs to a private Inspection chamber with an invert level of 200mm only. The foul drain has very little backfill above. We...
Hi,
I would be very grateful if i could get some advice on new foul drainage to an extension i am currently designing for a friend.
Currently, there is an SVP that runs to a private Inspection chamber with an invert level of 200mm only. The foul drain has very little backfill above. We...