i have a bosch exxel dishwasher and the door sometimes will not open with out sliding across a little orange tag which sometimes drops down within the grab handle reccess in the door, the machine works fine other this.
the impellor looked fine when i took the motor out, i also took the middle out inside the machine, under the filter, you can see the blades through there also and they look fine .
Hi my dishwasher ( no not her at the sink ) has packed up the water will only pump out if i hold the outlet pipe no more than about 40mm off the floor any higher and any water fails to come out. i can get an impeller for about £30 but i'm buggered if i can find a way into the area where the pump...
is it possible to solder chrome radiator tails to copper elbows? i'm putting a towel radiator in the bathroom and want to bring chrome piping out of the wall at right angles i would like to solder them rather than compression joints as they will eventually be behind tiles.
i used sentinel descaler together with a bottle of sentinel inhibiter. when the system packed in about a year ago it was out of action for about 5 weeks i'm assuming this didn't help any build up of scale, also after fitting the pump and refilling i neglected to replace the inhibitor :oops:
poping a bottle of descaler has made loads of difference, still pops and goes a bit. think i shall give it another couple of week then maybe another bottle added
tried it on fast speed no different i'll try a descaler as we live in a very hard water area. i'm assuming it will take a couple of weeks to work it's "magic"
having changed the pump last year after a small leak blew the pump up, and also a circuit board in the boiler, very troublesome to get the system running again, boiler would fire up for a few seconds then would cut out seemingly over heating. anyway got it all running ok apart from loud banging...