Recent content by diyknowhow

Thanks There is a danfoss room sensor TS2A installed also. Just changing it from "Chrono 6" to "on/off" shouldn't cause any damage to anything. By that I mean the physical setup of the pipes, cylinders, boiler etc can't be damaged by changing it to "on/off" on the TPOne. The installation is...

TPOne calling for heat all the time I have a Baxi Asuure Heat 19 boiler. A water cylinder with a small expansion tank next to it in a cupboard, I believe it is referred to as a closed system. All a couple of years old. Problem is the controller Danfoss TPOne keeps calling for heating...

sand down and paint again?

No

Also just looking at the area behind the radiator, just above the skirting board, the pink plaster doesn't look very smooth could it be more shapes like this that were painted over without smoothing.

No it's not been touched just standard matt white paint that the house builder painted the whole house in.

Please can anybody tell me what these marks are in my walls. The first photo shows the wall above a radiator in normal light. The next 2 photos show the same wall with a bright torch, what looks like worm shapes. If you press on them they don't go down, is this normal drying for a dot and dab...

six, to be clear you are saying the whole unit needs to be replaced each time a bulb fails. It looks like a Aurora EN-DLM356 only one i can find online with 2 ridges not 3 in the middle. Or can you take the whole thing out and put a new bulb in?

it's a new build...:cautious:

The big ring (outer) turns but I'm afraid to turn it too much in case the whole thing falls out.

Unbelievable!! Bloody new builds!!

Really??

Does anyone know how to change this downlight bulb? There are no clips like on the videos on youtube. There are only 2 ridges not 3 like the videos, where the middle nicely screws off. Completely lost? I can't turn the middle bit, does the whole thing have to come out?