Recent content by DJMW

Hi, thanks, yes, realised the high pressure idea was probably a red herring. I did shine a torch up there earlier today and couldn't see where the water was coming from, only that it was ending up with a drip on the inside of the threaded shaft of the tap, or down the cold flexi. This tap is...

I've just thought of something. The tap is listed as needing 'high pressure'. I don't know what my mains water pressure is (always thought it was fairly high) but I could turn it up higher. Perhaps the seals on the flexi pipes within the tap need very high pressure to seal properly? Has anyone...

Thanks for the replies. It is dripping most of the time - just seems like more straight after use. Amount of water: couple of mm (covering the base of a washing up bowl) in 6 hours (tap not in use during this time) - so not pouring out, but perhaps more significant than condensation.. No, it...

Thanks for the reply. I kind of thought that as long as the thing wasn't buzzing away the whole time and was keeping everything cold, the spaces I have would be ok, just got a bit worried when other forums/ manufacturers starting talking about 'overheating'.

This is a weird one... Bought and installed a hansgrohe e2 single lever kitchen mixer tap. The flexi pipes dangling from the bottom of the unit and dissapearing high up inside it appeared to be ready attached. Instructions were poor and didn't state this, but I felt it to be the case as there...

I recently bought a new free standing fridge freezer (LEC TS50152W). I bought this particular model as we have a very small kitchen and it's about the narrowest I could find. The manufacturers recommendation for ventilation space around the appliance is 25mm each side and 100mm at the back and...