Recent content by DodgySailor

£200? not too worry about the paint

Dear all, anyone can tell me how much can I expect to pay to fix this dent in a Mitsubishi Delica? I am not sure it is leaking, it is a van I am thinking to buy

Natural gas. I just want to make sure they are not trying to sell me stuff I do not need

I assume there is a gas filter to ensure the boiler burns clean gas

The gas filter. I have to admit that it has not been serviced for the 10 years I have it

Yes a Worcester. The vibration comes from inside the boiler. It happens after a few minutes running the heating. The vibration starts 0 to 10 and it stops abruptly and then after 50 seconds again

Dear all, My boiler is about 10 years old and recently it started to do an intermittent vibrating noise when running the central heating. A chap came and cleaned up and serviced it but the noise has come back the same day. They have quoted me £230 to install a new gas valve and replacing the...

No way I am doing something like that!

It is quite solid but I need to investigate further how deep down it goes, These easy pads look like a good idea for this. Thanks!

Dear all, I have disassembled the shed in my garden which was on top of a concrete floor about 3 x 2 metres and would like to build a small studio there. Is there any way I can make the studio a bit bigger by "overhanging" a bit over the concrete base so that I do not need to make the concrete...

I was building anticipation...

Hi I had a similar issue and i noticed the support for the top spray was loose and not engaging when the rack was put back into its position. I had to use cable ties to fix it back in place and ensure correct engaging to the horizontal water connection

Its a Zanussi about 10 years old (model ZDT 21002FAl)

Thanks, where can I find the heating element? it is not inside the dishwasher (not the horse shoe shaped rod) that you see in some.

Dear all my dishwasher stopped heating water and trying to find the reason I came across this plastic container which looks like it is clogged but I am not sure how to clean it. The containers looks sealed. Is there a way to clean it without having to disassemble it?