Recent content by Don23

Hi Mike, I never did install the heater. When I contacted Redring again for their approval for the final set-up, they withdrew their statement the heater could be used with a TMV and would not approve the solution. Quote "If the temperature set in the TS1503 valve is LOWER than the...

aj - Redring confirm Powerstream can be used with a TMV, so all systems go. Will be using a 12Kw Powerstream into a Horne shower panel incorporating an H15 TMV and a push button timed valve. Many thanks for your suggestions. D

Thanks again aj. Redring not got back yet, so will be after Easter now. In my last post, I should have said "blending" valve, not bypass valve! Sorry. Ideally, I would like to use a simple timed valve on the output whilst using a TMV3 (or TMV2) to regulate the temperature - I'm a bit...

Thanks for your suggestion aj. There seems to be some confusion whether the Redring heater can be used with a thermostatic valve or a bypass valve. I'm waiting for their tech. folk to get back to me. D.

Hi. I manage a small private swimming pool. There is a single shower cubicle fitted with a domestic electric shower unit. Mains water only; no hot water storage capability. Users are constantly breaking the buttons and damaging the controls. I would like to fit a remote (out of reach!)...

Hi Everyone, Many thanks for your helpful replies. Just to clarify for bengasman and softus...only one cubicle and the intention is to mount the heater remotely - in fact, the other side of the cubicle wall or in the roof space above. The only "hardware" in the cubicle would be 15mm pipe...

Hi Softus, Thanks for your reply - something I had not considered. Do you think this is an issue I should be worried about? Although I made the comment about "building a shower", it was for descriptive purposes. I'm really just plumbing a source of hot water (from an electric heater) to a...

Hi, Some advice please... Situation: I manage a small holiday complex with a swimming pool. Pool has a shower cubicle with an electric shower (usually a Mira or Triton). Problem is visitors constantly break shower controls, leave running, etc. I fit 2 or 3 replacement showers each summer...

Many thanks for prompt reply Davy. Ordered! Don

Hi, Just registered and my first post. I'm installing a Neff ceramic hob (6.6Kw) and SMEG oven (6.1Kw) on independent wall outlets. I'm using the existing 6mm supply (to the old oven) to feed the hob and I've run a second 6mm supply back to the cu to supply the new oven, each protected by a...