Recent content by DonDiy

Sorry seco services , been offline for a while. Checked out the microswitch and seemed secure enough, but then noticed the no 1 relay had been arcing, and the no 2 wasn't operating at all. Rather than risk it, have indulged in a new shower in the sales. Thanks for the advice anyway, much...

Number on PCB is 7073333 HK201435/E although the last letter is a little smudged, but fairly sure it's an 'E' Thanks for responding. :)

Soft water area. Stopcock fully open, water pressure is high. New hose and shower head, cleaned and checked for blockage. My Triton Opal II has been progressively more intermittent in heating. It always has been less effective in the winter, but now is barely heating. When operated on...

Thanks for the help guys, can't believe it was so simple. :D

Thanks Rocks1, I had hoped that was the case. Powered-up, waiting for the chill! :)

Thanks Leccy258: Have had about 2 litres of meltwater from the freezer, so hopefully that will help. Removed some of the freezer interior panels while cleaning and the circulating fan isn't running, although spins to the touch. Is there a delay when switching on after a defrost, should it...

Thanks for that - come to think of it, I stuck my fingers in the vent between fridge & freezer and could feel some ice crystals. I'll turn it off tomorrow and see how it goes. :)

Daewoo side-by-side Fridge Freezer FRS2021IAL The fridge is not cooling, at 15C last I checked. Freezer is keeping food frozen, but not as cold as it should be. The air is not circulating properly, if at all, thorough both the fridge and freezer. I removed lower back panel and found the...

I was sure it was continually sparking last night, but I've just checked again and now I can't see any sparking. Beginning to think I'm hallucinating. :)

Yes, pilot light is on throughout. Another thing is the 'power' light is flickering and although the pilot light stays on I think I can see sparking. GV - is that the gas valve? :?

Worcester Bosch 240RSF combi boiler. Soft water, high mains pressure. Pilot light is on, but burner doesn't fire up when demand is created. I've tested the pump electrically and it's working. I've also noticed that the green 'demand' light on the front panel does not light up regardless...

I've also noticed that the green 'demand' light on the front panel does not light up regardless of rad positions or hot water demand Could the diverter diaphragm or microswitch be the problem? Thanks

Not sure what red button you mean - if it's the honeywell reset than that's OK, it hasn't tripped. :?:

Thanks for the quick reply. I think I know the vent you mean, I haven't touched that at all. Could trapped air be the problem?

Worcester Bosch 240RSF combi boiler. Soft water, high mains pressure. I'll start by thanking everyone who has helped in the past to save me expensive call-outs. Now here's the latest problem! I replaced the pump head as suggested by KevPlumb in my last post...