Recent content by donnymac

no jenny ,as i said low amp, 12v 40amp.. does the job..

thanks guys for the info... im only doing minor repaires so will stay with the stick for now.. cannot use the mig because it needs to be portable and i dont have a power supply in the garage.. thanks again donny mac

is there a general rule of power to stick size or can i use anysize of sick with low amps, would be welding mild steel, car wings etc.

ford ford ford.... any pre 90,s ford... try american.

15.8v is to high, should be no more than 14v to a max of 14.5v. start to worry when you get a rotten egg smell coming of the battery, it becomes a fire hazzard when the battery starts to cook.

a car cannot fail an mot if the exhaust is not leaking, use anything from coke cans to bean tins at mot time, remember the exhaust has to exit from the rear or the side of the car to stop the gases entering the cabin..

hi, can anyone help with a question, low amp welder, what size of stick should i use and what sizes can you get. thanks donny mac

hi, i have a ikea/whirlpool dwf b10 dishwasher, after prog run it goes straight to rinse,light flashes 3 times with a constant beep, any ideas thanks donny mac

hi sleepyhead, i checked the light, when the prog ends the light flashes 3 times with a constant beeping and then goes to a rinse. help....

hi, looking for help with a whirlpool dwfb10. when a prog has ended the machine then re-starts on the rinse prog, also the salt led is always on, have no instuctions with the machine. please help. :?: