Recent content by Driller

You could try here. http://www.doepke.co.uk/cons2/conunits.html I've not fitted a dual RCD one but the split load one is quite narrow, unfortunately there's not too much space in it.

I use these, as the spring seems to help hold the lamp in place. Haven't had any call backs after fitting them. http://www.thelightbulb.co.uk/items-442/dichroic-lamps-amp-transformers/lamp-holder-and-retaining-clip

It's a plug connector with 2 spade type connectors in it, to which the wires are crimped. this pushes onto the two blades sticking out of the bottom of the ignition switch. There appears to be nothing wrong with the connector so why was it cut off? You wont get one of these from a spares...

They look like RPP (Proteus) grid modules. They're CEFs own brand so you'll only be able to get them from there. Hugh

Is this for use on an aircraft that's in service, or for a museum exhibit? If it's for an in use aircraft you could try posting on Pprune in the Engineers and Technicians forum.

What's this actually fitted too? The connector looks like the ones used on the Smiths Industries Fuel Systems on aircraft. Which would tie in with the 28Vdc. The size is about right and the pins are not equally set around the connector, so this would be the indicating side rather than the...

Have a look at the installation guide that came with the shower or download here http://www.mirashowers.co.uk/onlinecatalog/pdf/sprint11f21ff4c9a.pdf. Trouble shooting guide starts on page 27. There are several things it could be

Bu**er. You posted while I was typing. Glad you fixed it.

Ok. To clarify. With the shower isolator pull cord switch on, the neon in the pull cord switch illiuminates. When you turn the top control on the shower to any position but stop the water does not flow. Is that correct. When the top control on the shower is set to Low, Medium or...

Isolate the circuit at the CU and then open the pull cord switch. Have a look for burnt or loose cables. Seems like you may have a high resistance joint and that's the most likely place. It's not uncommon to find the switch or contacts burnt out.

If it doesn't have a retaining ring, then you need to twist the bulb anticlockwise. the lamp connector is fixed to the base of the can. Those fittings usually come with a rubber sucker to stick to the lamp to help you twist. They soon get lost. You need to press firmly but carefully on...

Try Here http://www.credaheating.co.uk/spareparts/

Most dimmers wont work below a minimum wattage. As most of your problems seem to be with the single lamp/dimmer set up I would look at that first. Put a 60W tungsten lamp in and see if it dims properly, if it does then you need to increase the load on the dimmer or find a dimmer that will...

I'll come if you pay the mileage, but I'm up in North Wales. Did you swop the fuse holders over just to check that the holder isn't faulty? I know you checked it with a continuity tester but it may be failing under load.

Did you check the fuses with a continuity tester? or just visual. Are they cartridge fuses or rewireables? Sometimes on cartridge fuse holders the spring contacts that hold the fuse get weak and dont grip it. If that's ok has anybody done any drilling or nailing anywhere that may have...