If I remove the old wires going to [1] and [2] in the boiler and wire :
Live L 'Live' goes to the boiler Live
Hive N 'Neutral' goes to the boiler Neutral
Earth to earth tether.
That's it? I don't need to wire from [1] or [2] to the hive receiver?
Hey,
Thanks for reply.
You can access panel without opening sealed section of boiler.
I have a thermostat right now in the corridor. This is wired to connections [1] and [2] on the boiler.
Otherwise you advice seems to be what I think as well.
Hey,
I have a new Hive thermostat. Looking to fit to a InTec² 28XE boiler.
The boiler wiring is shown here:
Boiler by DrRadar posted 6 Jan 2018 at 12:44 PM
The Hive wiring diagram is shown here:
Hive by DrRadar posted 6 Jan 2018 at 12:43 PM
So far I have:
Boiler Mains cable...