Hi, I've ordered the capacitor - I have not had a chance to inspect the existing one as I have to drain the hot water tank and disconnect the pump in order to get to a couple of the screws.
I'll take the risk so that I can hopefully get the new one by Friday and fit it over the weekend. If it...
Hi, serial number is 1667159/5104/W37895
Can you advise how I go about ordering a new capacitor for this pump? Do I need to go via your web site?
Many thanks, Eddie
Thanks, I'll try and get a closer look at it this evening if possible and get any details I can off the capacitor and the serial number from the pump.
Regards, Eddie
Hi StuartTurnerLtd, turns out that it is one of your older model pumps - a Monsoon 2.0 bar single.
I've checked the impeller housing and there does not seem tyo be any obstruction. Did not get a chance to check the capacitor but I am fairly sure it is the culprit.
Is it possible to get a...
Hi, many thanks for the replies.
I was thinking in terms of the capacitor but I can't remember my motor control stuff from Uni as it was so long ago and I didn't want to look too much of a numpty.
It is fairly easy to get to and has push fit connectors so I may try opening up the impeller...
Hi, I live in a single floor flat with a standard immersion heater hot water tank. As there is insufficient head between the water tank and the taps/shower the original plumber installed a single impeller hot water pump in order to drive them. The cold water is mains fed throughout. I replaced...