During the process of grouting surplus grout is normally wiped away with a wet sponge, which is fine. But after the grout has dried there is normally a thin layer of dried grout left on the tiles by the sponge which can conceal the gloss of the tile. The normal way to clean this off is to use a...
Hi Beerlover
Many thanks again for the pointers. I will have a go and let you know :x :D
ellisjean
Hi Beerlover
eureka!! I pressed the right hand side of the rocker switch and the boiler fired up. So I will strip it down and give it a good clean over the weekend.
Many thanks for your...
Hi Egg1
Could you set up a temporary fence to the pillar drill base, position so when you place your timber against it your drill bit is in the centre?
If you have any 'G' clamps you could use them to hold the fence in place, and use other 'G' cramps to hold your timber against the fence so it...
Hi Beerlover
The water valve is working for the hot water, the pin comes up and activates the micro switch, so I assume this isnt shot!
When the room thermostat call for heat the pump fires up on the boiler but nothing eles! What does the diverter valve do? How would I know if this is faulty...
Hello
Can any one help with this.
We have a Vaillant combi boiler, its about 20 yrs old, ref VCW GB 242 EH.
The boiler is working fine for the domestic hot water, but it will not fire up for the central heating! The pressure is when cold is always at 1bar.
Thank you :?: