Recent content by elmsoft

Excellent reply. Thank you so much

Hi Everyone Recently my 10 year old Beko double oven has started tripping the RCD shortly after switching on. It does this with either oven and sometimes does reach the set temperature and sometimes doesn't. It really does seem like an intermittent fault arising from varying circumstances . So...

Struggling to latch my back door and on inspection there is a distinct bow. When closed, the top and bottom are tight against the seals but at the door handle there is a clear gap of maybe 5 mm. I hadn't appreciated that uPVC could warp. Is there away of straigtening the door? thank

It is insulated but must be some sort of airgap. Years ago I used Sadolin on my own barge boards and that has been successful. Can't believe merchants sell untreated shiplap. Why??!

does that mean not to use sealing paint?

I've been asked to advise a friend about replacing rotting shiplap. Problem is it all seems rotten. I The shed has been well painted with (expensive ) Cuprinol and is only about 10 years old. Surely the material should last better than this?

I've been asked to advise a friend about replacing rotting shiplap. Problem is it all seems rotten. I The shed has been well painted with (expensive ) Cuprinol and is only about 10 years old. Surely the material should last better than this?

Thanks for the input , guys. Pretty sure the glass is nothing special and 4mm seems a good bet. I'll go with the 28mm . 4+4+20

HI I need to replace a blown unit so I've taken it out and measured it at 27mm depth. Replacements are available in increments of 2mm. Do I go for 26mm or 28mm? Thanks for reading

Thanks for advice. Will do.

A friend lives in a cottage in Dumfries and wants to isolate his water supply. Removing the lid of the access chamber reveals this bit of kit. I had expected a valve of some sort but have no idea what this is or how to operate it. Anyone know how it works?

This is more a blog now than a request for help!:) Removed tonnes of stuff. The under bonnet scuttle - So I can see the air intake and clear daylight where the fan was Passenger side footwell duct . Clean and clear as new:) Radio and heater controls show the bowden cable is working fine...

The fan makes plenty of noise so I will take your advice and check fuses to start with. Maybe I'll get lucky:) Thanks everyone

Good advice . Thanks

Worth a try. Easier than dismantling the whole dash which is my next option:):)