Recent content by EmmaLast

I have checked and mine are all Backer. Thanks everyone you have all been really helpful.

Maybe I should look at changing all the thermostats then??? This doesn't just happen to one thermostat but has happened to most of them over the last couple of years so I don't think I can put it down to one being faulty but maybe I have an unreliable/low quality brand? I am not sure what make...

I'm sorry but I'm not sure as the first I know there is a problem is when I have cold water.

Also, all the thermostats are set at 60 degrees. I can't lower them and meet legionnaires requirements as far as I'm aware.

Thanks for the replies. I should have said, the cylinders are not connected, feeding separate areas. I have double and single immersion cylinders like this...

Hi, I am new to this forum but hope you guys can help... ...I run a business with quite a few hot water cylinders. When the nature of the use changes (ie when we go from a busy period to a quieter period) I find that sometimes the safety cuts in on the immersion thermostats. No problem with it...