How water on its own is not kicking the boiler in. Only when heating is turned on.
Wiring is shown below, but with earth all connected to earth in the hive.
I have managed to connect it up so the heating is on, by re-installing old thermostat. However that is showing red, that temp has been reached.
When I solely put hot water on the boiler isn't firing up. So unsure if not water is functioning when heating on or not.
Really confusing situation...
Ok, is it still possible to use the Hive?
Have attached another picture as I think I'll need to amend wiring here as I have removed the old thermostat.
Have searched the site for solution and couldn't find one for my problem, hopefully someone is able to advise on where I have went wrong.
Formerly had potterton EP2002 controller connected to my BAXI system boiler 60/100. (See photo)
This also had a thermostat wired in and has a hot water...